Arris WR2100 User Manual download pdf (Page 8)

Step 8: Now you can select a suitable location for the WR2100

Wireless Repeater. It's preferable to place the device near the center of

your wireless coverage area. Check the LED color and make sure it’s

not red. Next go to “Setting Up Your Client Devices”.

Locate the WR2100 Wireless Repeater in another

place for better wireless reception and performance

if the signal strength is weak (the LED is red).

Manual Configuration with a PC

Step 1: Make sure the PC is connected to the Wireless Access Point

with a good signal.

Step 2: Prepare an Ethernet cable. It should be long enough to connect

the WR2100 Wireless Repeater to your PC.

Step 3: Plug the WR2100 Wireless Repeater into the power outlet and

press the Power button to power it on.

Step 4: The LED stays on for a few seconds then starts blinking. Wait

for the Power LED to be static on again. The WR2100 Wireless

Repeater is now ready for use.

Step 5: Connect the Ethernet cable to the WR2100 Wireless Repeater

and the PC.

Step 6: Launch the browser and enter http://www.mywifirepeater.net/ in

the Address box.

Step 7: You will then be prompted for a username and password. If

using the default values, enter admin for the username, and password

for the password.

Step 8: Choose the Wireless page and click the “Site Survey” button.

The WR2100 Wireless Repeater will start to search the existing

wireless networks.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Arris WR2100 User Manual Page 8