Arris WR2100 User Manual

i Touchstone® WR2100 Wireless Repeater Quick Installation Guide

8 Step 11: The connection of the WR2100 Wireless Repeater and Wireless Access Point is successfully established after the LED remains on. Next go

9 Troubleshooting Devices that do Not Support the Block ACK Feature Wireless access points and wireless routers that use the older IEEE 802.11g or

10 Appendix A Specifications WR2100 Wireless Repeater Model 802.11N Wireless Repeater 2.4GHz 2x2:2 MIMO Dimensions 67mm (W) x 85mm (H) x 36mm (D) Op

11  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an ou

12 Copyright © 2012. All Rights Reserved. All information contained in this document is subject to change without notice. A

ii Package Contents The following items should be included: If any of these items are damaged or missing, please contact your service provider imme

1 Chapter 1 Introduction This Chapter provides details of the WR2100 Wireless Repeater’s features, components and capabilities. Overview The Touchst

2 Chapter 2 Basic Setup This Chapter provides details on how to setup the WR2100 Wireless Repeater. System Requirement  To use the wireless interf

3 1. Power LED (Green/Amber) On (Green) - Power on. Off - No power. Blinking (Green) - The Power LED will blink during start up. This will take 1

4 Bottom & Side Panel 1. LAN port Use a standard Ethernet cable to connect your WR2100 Wireless Repeater to a PC. 2. Power On/Off Switch Pr

5 Setting Up the WR2100 Wireless Repeater The installation allows the WR2100 Wireless Repeater to directly connect to a wireless router (or Wireless

6 Step 8: Now you can select a suitable location for the WR2100 Wireless Repeater. It's preferable to place the device near the center of your

7 Step 9: Select the desired SSID that you want to connect to. Click Next. If you can’t find the SSID, make sure the Wireless Access Point SSID is