Arris WBM750 User's Guide download pdf (Page 15)

Instructions

Wall-mounting instructions

Note: When mounting the Wideband Cable Modem on drywall, try to position

the modem so at least one of the screws are fastened to a stud. This

may prevent the Wideband Cable Modem from pulling out of the wall in

the future.To prevent overheating, do not block the ventilation holes on

the sides of the unit.

1 Position the mounting template on the surface where you intend to mount

the Wideband Cable Modem and secure in place with transparent tape.

2 Drill holes through the template in the speciﬁed locations for the mounting

screws. After drilling holes, remove the template from the surface.

3 If using drywall anchors, set them into the wall. Then, drive the screws into

the wall leaving a gap of about 1/8” (3 mm) between the screw head and

the wall. If not using anchors, just drive the screws.

4 Orient the Wideband Cable Modem with the indicator lights facing up or

right, as desired. Slip both mounting slots (in the back of the Wideband

Cable Modem) over the screws, then slide the case down until the narrow

end of the keyhole slot contacts the screw shaft.

5 Proceed to Connecting the Wideband Cable Modem

Desktop mounting instructions

1 Position the Wideband Cable Modem so that:

• air ﬂows freely around it

• the back faces the nearest wall

• it will not fall to the ﬂoor if bumped or moved

2 Proceed to Connecting the Wideband Cable Modem

Touchstone WBM750 Wideband Cable Modem User’s Guide

Safety

Getting

Started Installation

USB

Drivers

Ethernet

Conﬁguration Usage Troubleshooting Glossary

Step 1

Step 2

Step 3

Step 4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 54 55

No comments

Arris WBM750 User's Guide Page 15